Shacman fault codes — Weichai lookup

Shacman F3000, X3000, H3000 and 6000 usually run Weichai WP10–WP13, sometimes Cummins ISM11. Same code family as Howo/Sitrak, different loom. Pick Shacman on the form, not a generic Howo tip.

Engines

F3000: WP10/WP12/WD615. X3000: WP12/WP13/ISM11. 6000: WP13/MC13. ISM11 adds Cummins numbers; WP is P0087, P0193, P0299, P0401.

Symptoms

• no pull on a hill;
• no start after a night;
• derate;
• lost ECM on CAN.

Frequent Shacman codes

• P0087 — low common-rail pressure
• P0088 — high common-rail pressure
• P1011 — HP pump metering valve fault
• P0093 — large fuel leak / CAN trap — FMI needed
• P0193 — rail pressure sensor high signal
• P0299 — boost below target
• P2263 — turbo / boost performance
• P2563 — VGT position sensor — range / performance
• P0335 — crankshaft sensor no signal
• P0340 — camshaft sensor (CMP) — FMI needed
• P0401 — EGR insufficient flow
• U0100 — lost communication with engine ECU
• U0101 — lost communication with TCM
• U0155 — lost communication with instrument cluster
• P0562 — system voltage low
• P0201 — cylinder 1 injector circuit
• P0480 — fan control circuit
• P0217 — engine overheat
• P0116 — water in fuel (Weichai table) / not always coolant SAE
• P2509 — intermittent ECM power (no OEM in DB)
• SPN 2898 — without FMI — not a diagnosis (config / Weichai grid)
• SPN 729 — intake heater — FMI needed

Weichai internal P-codes are not always SAE. Read the scanner caption. Home form: Shacman + engine.

Fault code table

Shacman codes: Weichai/Cummins engine and EBS. For X6000 also see the X6000 landing.

Full step-by-step — enter the code on the home page. If a card exists, click the code.

Look up the code in the service